RC MAKER Xray X4-2024 GeoCarbon Bumper Plate with Stopper

RC Maker Product Description:

Our brand new GeoCarbon bumper with stopper for XRAY X4'24 impresses with its elegant, unobtrusive and innovative design. The plastic X4 bumper and stopper, while effective, in our eyes not the most elegant solution to keep your chassis safe in the event of an accident.

Our design integrates the stopper under the main bumper, which is connected to a lower flat section on the front bulkheads. In the event of an impact, the force is transmitted through this lower section of the bulkheads, keeping the chassis in tact with minimal impact to the bulkheads. The 4 mm thick, heavy-duty strut slides over the small bumper posts so that it is low enough to connect to the bulkhead. When tightened, the top plate firmly clamps the entire assembly.

At rest, a 0.1-0.2 mm gap is left between the bulkheads and this support to prevent rubbing and pinching. This support only becomes active in the event of a crash! This is the optimal solution to keep the chassis of your brand new X4'24 safe and looking good at the same time!

Our new Bumper Plate has three holes that allow you to adjust the body forward and backward like standard plates do. The integrated stopper does not move, it stays in the same place regardless of the position of the body post! Unlike other stoppers, our stopper can stay in place when the front stabilizer bar is removed, and does not have to move when the front flex brace is used or not!

This gives you a sleeker, more durable, and more convenient solution than the stock parts.

Installation:

Slide the small bumper stopper over the plastic posts with the recess facing down. It is a hard press fit and should snap into place and sit flush with the plastic posts. 

Install the upper bumper bracket and screw it into the holes with the desired screws.

Features

• Elegant GeoCarbon CNC machined design made from 3mm carbon  
• Integrated 5mm thick bumper bracket to protect your chassis
• Adjustable position of the body mount as included in the kit
• Does not need to be removed to remove the stabilizer bar
• Direct replacement for stock tops and stoppers, no modifications required
• 100% made in Australia