T-Work`s 0.5mm Front Roll Center Spacer for Mugen Seiki MTC-2 (2)

With these practical aluminum shims you can make changes to the roll center quickly and easily. Just loosen the screws of the lower control arms a little bit and the washers can be pushed in or pulled out - a simple and ingenious alternative to the normal single aluminum shims. The included thin shim washers have to be installed once under the alunminium spacers when using the original carbon fiber chassis. They compensate for the  minimal indentation in the carbon fiber chassis of the MTC2.

Pro tip: "After changing the roll center on the lower control arms, the suspension travel must be readjusted or adjusted each time."

The following roll center spacers from T-Work`s are available for the MTC2 from Mugen Seiki:

T-Work`s 1,0 mm Roll Center Spacer FRONT (2 pieces) TW-TE-230-J-1

T-Work`s 0,5 mm Roll Center Spacer FRONT (2 pieces) TW-TE-230-J-0.5

T-Work`s 1,0 mm Roll Center Spacer REAR (2 pieces) TW-TE-230-K-1

T-Work`s 0,5 mm Roll Center Spacer REAR (2 pieces) TW-TE-230-K-0.5