HUDY Air Remover Onroad 1:8, 1:10 & 1:12

The HUDY shock pump for 1:10 onroad shocks is perfect for quickly bleeding the shocks.

You can put 4 dampers with a diameter of up to 14.6mm in the holder and bleed. So you can use the dampers of all common 1:10 touring cars with it.

The vacuum pump pulls the air out of the cylinder and thus the unwanted air in the damper is pulled out by the oil. The pump helps you especially when you don't have that long on a race and still want to fill your shocks properly with new oil between two runs. It's also a cool piece of equipment and looks super professional.

The vacuum pump is powered by 12V and for this a connection cable with 4mm plugs is included.

This is how the Hudy vacuum pump is used:

1. Fill the damper with new oil and put it in the holder (move the piston rod up and down so that the first air bubbles develop).

2. Place the cover (cylinder) on top.

3. Bleed screw in the cover (cylinder) until it is airtight.

4. Connect to 12V power source.

5. Push the lid down slightly (so that the rubber seals well when creating the vacuum at the beginning). Then PRESS and HOLD the red button. It takes only a short moment for the vacuum to be drawn. When the pump is finished, the sound will change. Please DO NOT let the pump run endlessly - this can damage the pump.

6. Now wait... The vacuum is in the housing and the bubbles will come up immediately. Thin oil needs about 30-45sec waiting time - thick oil needs longer. When no more bubbles are visible you can remove the dampers.

7. To do this, slowly unscrew the bleed screw on the cover to let air in.

Contents:

1 x Hudy vacuum pump (incl. damper holder and lid)

1 x Connection cable (4mm plug)

1 x transport bag